|
Who's Online
There currently are 5993 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
Chapter 5 Using the Internal Effects (VS8F-2)
(Send Level) This adjusts the volume level of the signal (0�127) sent to the EFFECT bus. Set the initial value to �100.� (Send Pan) This adjusts the stereo placement of the signal (L63�0�R63) sent to the EFFECT bus. �L63� is fat left, and �R63� is far right. Set the initial value to �0� (center). 4. At this point, the effects are set up so that they will be add to the sound. Press [PLAY (DISPLAY)]. Return to Play condition. * You can insert EFX2�EFX4 in the same way.
Return Level
Adjusting the Return Level You can adjust the volume of the effect sound (Return level) with the channel faders on the top panel. Use the following procedure. 4-1. Press the input channel [EFFECT 1/3 RTN] button. The Effect Return screen appears in the display. 4-2. Press [F3 (EFX1)] or use [ ], [ ], [ ], and [ ] to move the cursor to �EFX1Rtn.�
fig.05-09(channelrtn.eps)
Return Balance
(Return Level) This sets the volume level (0�127) of the effects. Set the initial value to �100.� Use the channel faders for this. (Return Balance) This adjusts the left-right balance (L63�0�R63) of the effect. Set the initial value to �0� (center). 4-3. Press [FADER] so that the IN indicators light. At this time, the EFX1 return level can be adjusted with the EFFECT1 fader. Similarly, the EFX2 return level can be adjusted with the EFFECT2 fader. * When you wish to adjust the return levels of EFX3 and EFX4, hold down [SHIFT] and press the input channel [EFFECT 1/3 RTN] or [EFFECT 2/4 RTN] buttons. The SHIFT button indicator lights. Now, the EFX3 return level can be adjusted with the EFFECT1 fader, and the EFX4 return level can be adjusted with the EFFECT2 fader.
Chapter 5
107
$4.99 VS-1680 ROLAND Quick Start Quick start guide ( sometimes called quick guide ) contains most important information on how to use…
|
|
|
> |
|